The Fresh Loaf

A Community of Amateur Bakers and Artisan Bread Enthusiasts.

Hamelman's Whole Wheat Multigrain Bread

pmccool's picture
pmccool

Hamelman's Whole Wheat Multigrain Bread

The formula for this bread is from the second edition of Hamelman's Bread.  It's a 50/50 white/whole wheat bread with a multigrain soaker.  It is leavened with both a sourdough levain and a yeast kicker in the final dough.  The multigrain soaker composition is entirely up to the baker.  In this version, I used flaxseed meal, whole millet, and a blend that includes sunflower seeds and flaked wheat, barley, rye, and oats.

The levain and the soaker were set up before I went to bed.  Since nights are getting frosty here in northern MIchigan, the levain was stashed in the B&T proofer at 75F.  It was 11:00 a.m. the next day before I could start the final dough, so the levain was nice and bubbly. 

All of the ingredients were placed in the bowl of my KItchenAid mixer.  Hamelman's recommended mixing and kneading times resulted in a fairly firm, though not dry, dough. The dough went back into the proofer for bulk fermentation, which proceeded very nearly as described in the book.

Since it just two of us (and a lot of days just one of us) who eat the bread, I elected to shape three medium-size loaves, rather than the two large loaves mentioned in book.  The shaped loaves were placed on a lined sheet pan for the final fermentation.  Happily, the dishwasher was running, which meant that the countertop immediately above the dishwasher was nice and warm; so that's where I placed the sheet pan with the loaves. 

When the loaves had nearly doubled in volume, they were slashed and placed in the preheated oven.  I added boiling water to the steam tray and closed the oven door.  The loaves expanded very well in the humid heat, forming prominent ears.  Hamelman notes that the oven temperature can be lowered if the bread browns too rapidly.  I didn't and the breads is, to use Hamelman's own words, boldly baked.  At least that's what I told my wife when she said it was burnt.  It wasn't, as you can see here:

I've made a note for myself to add some more water the next time I make the bread.  It rose well and had a good oven spring but the crumb would have been more open if the dough was looser. 

The bread tastes wonderful, as is typically the case with Hamelman's breads.  The crumb is firm and moist.  The crust is crisp, with a bit of crunch at the ears.  Lots of wheaty, nutty, roasty flavors to enjoy.

Paul

 

Comments

gavinc's picture
gavinc

Nicely baked Paul. I've made this often and love it. I drop the oven temperature from 238C to 215C after about 15 minutes but still give them the full bake. I mostly bake from Hamelman as his formulas and instructions are very reliable. Two 750g loaves at a time on a baking stone.

Cheers,

Gavin 

pmccool's picture
pmccool

Hamelman's formula, that is.  And yes, I'm pretty pleased with how this one turned out.  If I have my wits about me the next time I make it, I'll try turning the temperature down during the bake and see how I like that. 

Paul

trailrunner's picture
trailrunner

I have his books and have only used them 1 x!! I'll have to give this a try. You say you added boiling water to the steam tray. So you aren't doing all the stuff with wet cloths etc ? I'd try just adding boiling water as I can shut off the convection with a switch but I'm not going to fool with a lot of other stuff to get steam. I had to bake each of my boules alone in my huge oven because of the size of my granitewear roaster so it would be nice to try your method if there isn't a lot of ' fol de rol " LOL !  

pmccool's picture
pmccool

Oh, you definitely need to try some additional breads from Hamelman's books!  Lots of wonderful formulae and guidance there.

Re: steam tray.  I've futzed around with different steaming approaches, although I haven't played with Sylvia's magic towel setup.  The one that I used most was placing the broiler pan on the lower shelf and pouring boiling water into that for steam.  All kinds of surface area and, since it was enameled, I didn't have to worry about the pan rusting.

However, when we moved into this house four years ago, our new stove came with a dedicated steam tray.  There's an enameled pan that clips to the bottom of one of the racks.  It spans the full width of the rack and is about 6" from front to back and maybe an inch deep.  It's really convenient, being located at the front, and easy to pour water into without splashing.  The rack doesn't even have to be pulled out to access the tray, so no slopping hot water around.  I have to hand it to the folks at KitchenAid because it's a notion that never occurred to me.  Here's a picture:

No folderol required.  Sadly, I haven't seen an after-market equivalent for other ovens.

Paul

trailrunner's picture
trailrunner
pmccool's picture
pmccool

You could even set it on the bottom rack without having to monkey around trying to attach it under the rack, assuming that you don’t need the rack space for the bake.

Paul

JonJ's picture
JonJ

Interesting equipment and they sound like very delicious loaves, especially like that your seed mix has millet in it.

I use stainless steel hotel pans for my steam trays, but need to bung the vents in my oven door with foil to keep the steam in. 

-Jon

pmccool's picture
pmccool

And yes, the bread is delicious.  I enjoy the crunch that the millet brings.

I haven’t tried to plug the oven vents.  So long as there is still water boiling off in the steam tray, I figure there's adequate humidity in the oven cavity.  Since I haven’t shorted out the electronics yet, this appears to mitigate the risk of steaming the controls.

The hotel pans sound like a good vessel for a steam tray.

Paul

Benito's picture
Benito

Beautiful baking Paul, you would impress Hamelman himself I am certain.

Benny

pmccool's picture
pmccool

Every now and then the stars align and I make something that is as appealing to the eye as it is to the tongue.

Paul

trailrunner's picture
trailrunner

Happens a lot around here. 🙏❤️

Isand66's picture
Isand66

This is an excellent bake Paul.  Similar to my last bake I imagine.  For steam I don’t have anything as fancy as you 😉 and I simply have a heavy duty rimmed baking sheet that sits on the lowest shelf of my oven.  I pour 1 cup of boiling water in the preheated oven as soon as I launch the dough.  I also have 2 baking stones.  One right above the steam pan and one on the top shelf.  Can’t complain about my results.

Best regards,

Ian

trailrunner's picture
trailrunner

I am going to definitely simplify and steam the way you all are doing it. I was put off with all the towels and stuff but I can definitely. go for simple. Will let you know how it goes.c