Quanah Spelt Coffee Sourdough

I have not made a bread with coffee in a long time so I figured it was time to try one again. 

I used one of my favorite whole wheat berries from Barton Springs Mill Quanah along with some spelt berries and milled fresh flour. The Quanah was sifted and milled twice and the Spelt was sifted once and milled twice both with my MockMill 200. I milled the whole grains in my MockMill200, sifted with a #30 sieve, re-milled and then sifted with a #40. I save the bran to add to my levains which I find give them a nice boost.

I used a dark roasted coffee blend for the coffee flavor and added some dark maple syrup infused with coffee beans as well.

The end result was a flavorful loaf with hints of coffee and a nice open crumb.

Formula

Levain Directions 

Mix all the levain ingredients together for about 1 minute and cover with plastic wrap.

Let it sit at room temperature for around 6-7 hours or until the starter has almost doubled. I used my proofer set at 76 degrees so it took around 5 hours for me. Either use in the main dough immediately or refrigerate for up to 1 day before using.

 Main Dough Procedure

Note: I use an Ankarsrum Mixer so my order of mixing is slightly different than if using a Kitchenaid or other mixer. Add all your liquid to your mixing bowl except 50-80 grams. Add the levain in pieces and mix for a few seconds to break it up. Next, add all your flour to the bowl and mix on low for a minute until it forms a shaggy mass. Cover the mixing bowl and let it rest for 30 minutes to an hour.   Next add the salt, maple syrup and remaining water as needed and mix on medium low (about speed 3) for 18 minutes.  If you are using a more traditional mixer you would only mix around 7-10 minutes.

Remove the dough from your bowl and place it in a lightly oiled bowl or work surface and do several stretch and folds.  Let it rest covered for 10-15 minutes and then do another stretch and fold.  Let it rest another 10-15 minutes and do one additional stretch and fold.  After a total of 1.5 hours place your covered bowl in the refrigerator and let it rest for 12 to 24 hours. I use my proofer set at 79-80 degrees. If you are leaving it at room temperature 72 degrees I would let it sit out for 2 -2.5 hours before refrigerating. Depending on how developed the dough is after the initial mix you may not need to do as many S&F’s.

When you are ready to bake remove the bowl from the refrigerator and let it set out at room temperature still covered for 1.5 to 2 hours or if using a proofer set at 80 degrees for 1 hour.  Remove the dough and shape as desired and cover with a moist tea towel or plastic wrap Sprayed with cooking spray and let rise at room temperature for 1 1/2 – 2 hours.  (I use my proofer set at 80 F and it takes about 1 hour to 1.5 hours but I should have let it go further on this bake). You will need to judge for yourself if you have a nice fermented dough before baking in the oven. I also added the topping mix directly to the bottom of my bannetons and rolled the dough side to side to make sure I had good coverage. You can also spray a a tea towel and then sprinkle the topping on the towel and roll the dough onto the towel.

Around 45 minutes before ready to bake, pre-heat your oven to 540 degrees F. and prepare it for steam.  I have a heavy-duty baking pan on the bottom rack of my oven with 1 baking stone on above the pan and one on the top shelf.  I pour 1 cup of boiling water in the pan right after I place the dough in the oven.

After 1 minute lower the temperature to 455 degrees.  Bake for around 35 minutes or until the breads are nice and brown and have an internal temperature around 200-210 F. 

Take the bread(s) out of the oven when done and let them cool on a bakers rack for as long as you can resist.